It will not go into Freewheel mode I checked linkage everything is up to date I have lifted the ass end of the tractor up I can move the tires when I turn one tire one way the other Tire will turn the opposite it will not go into neutral. The motor will start at fine and run strong but the transmission drive belt squeaks and I have burnt it up at the pulley on the bottom of the engine.
I have tried to disengage the transmission and put it in flywheel mode it will not push forward or backwards. Other than the burning of the belt, the rest of this isn't terribly abnormal. The hydro release is supposed to work by aligning the ports inside so fluid won't push back through creating resistance, but many behave the same way as yours. So if the linkage externally isn't obstructed , there isn't much worth doing here.
If your input pulley is turning freely and not lots of lateral play in the shaft- you are probably fine putting a new belt on it. It may be worth removing the drive pulley to see that it isn't splitting or in need of a scuffing due to it polishing itself on the belt.
Similar issue. My Poulan Pro will disengage though. Problem is, if you push the right side pedal to travel forward then release, it still travels slowly forward. Resulting in a loud click from the area of the transmission. New CVT transmissions. Any experience? Tractor won't go forward or reverse. Okay I have checked the pulleys and they are free and not bound. I have disconnected all linkage hand I removed to the belt off of the top of the transmission. Same thing the transmission will not disengage.
Hey, guys Any thoughts on my issue? Fluid change maybe? Is your tractor the exact same model number? It would be best to post as there are different transmission styles. This way you can get the right info. Ideally start a new post, but we can deal with this one if need be. I have a pp that quit running in the middle of the yard. I cant push it to get it to the garage because it wont go into neutral.
